Calibration Software Tabs; Basic Control Tab - GE T2100-ST1 Service Manual

Calibration Software Tabs

Basic Control Tab

Start Running Belt: Select Start Belt
Speed Control: Press
0.1 mph.
•
Select
Double-click on Set Speed
•
Stop Running Belt:
maintain 0.0 mph for about 3 minutes before the belt starts to
freewheel.
MPH Versus KPH: The software is configured to run in MPH as a
standard configuration. When it is desired to run in KPH, check the
KPH
box. The next time you select
function in KPH.
Grade Control:
.5%.
You have two ways to change grade:
•
Select
Double click on Set Grade
•
COM port: Interface COM port with host system.
2097937-002 Rev G
11 March 2019
one time. The running belt will start at
You have two ways to change speed:
or and adjust to the desired speed
Stop Belt
Select
Press one time. the elevation will increase to
or to adjust elevation by .5% per click.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
and type in the desired speed
. The running belt will go to and
Start Belt
, the treadmill will
and type in the desired grade %.
Calibration
175