GE T2100-ST1 Service Manual page 135

16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
2097937-002 Rev G
11 March 2019
front roller and lift the front roller up and out of the
treadmill.
Use caution to avoid pinching the belt.
Slide the rear roller out of the rear of the treadmill side rails
and remove from the treadmill.
With the ½" wrench or socket with extension, remove the
(4) bolts securing the deck cross braces to the treadmill side
channels.
Using caution to avoid damage to the antistatic tinsel run
between the (2) front bolts, remove the cross braces from
the treadmill and set the cross braces and the tinsel aside.
Verify all pieces of the deck cushions are accounted for and
set aside.
Remove the old running belt and replace with the new
running belt.
Verify the guide for the belt deck and rollers is to the left
during installation.
Replace the (2) deck braces and deck cushions; start the
deck braces securing bolts but do not tighten them.
Replace the antistatic tinsel using the (2) from deck brace
bolts.
Replace the rear roller, pushing the rear roller as far
forward as possible.
Do not replace or start the tensioning bolts at this time.
Verify the guide for the belt deck and rollers is to the left
during installation.
Slide the front roller between the running belt, place the
timing belt over the sprocket of the front roller between the
running belt, and place the timing belt over the sprocket of
the front roller.
Replace the front roller.
Verify the guide for the belt deck and rollers is to the left
during installation.
Verify the timing belt goes around the front roller sprocket
and is not pinched.
Replace the securing bolt and tighten.
Lift the edge of the running belt and slide the deck onto the
deck braces.
Tighten the cross brace securing bolts.
Use caution to avoid over tightening the bolts.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Component/FRU Removal and Replacement
135