Using The Test Plug - GE T2100-ST1 Service Manual

Assembly and Setup
1
Item

Using the test plug

1.
2.
3.
4.
44
2
Description
1 RS232 Port "Female"
2 USB "B" Port
Turn the power "OFF" at the treadmill.
If connected, remove the RS232 or USB interface cable from
the treadmill and plug in the test connector into the RS232
port.
Press and hold the button on the test connector and turn
the treadmill power "ON". Continue holding until the
treadmill begins to elevate.
When the treadmill begins to raise, repeatedly press the
button to cycle through the different phases of the test.
The following table shows the sequence of self-test stages:
Stage Incline
1 5%
2 10%
3 15%
4 20%
5 20%
6 20%
7 20%
8 20%
9 20%
10 15%
11 10%
12 5%
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Speed (mph)
0.0
0.0
0.0
0.0
1.0
2.5
5.0
7.5
10.0
7.5
5.0
2.5
2097937-002 Rev G
11 March 2019