Exterior Care; Elevation Screw Lubrication; Running Deck Maintenance - GE T2100-ST1 Operator's Manual

Exterior Care

The powder-coat finish on your T2100-ST1 or T2100-ST2 treadmill is
an extremely durable finish and requires minimal care. Do not allow
perspiration to build up on your treadmill. Wipe the unit daily.

Elevation Screw Lubrication

The Elevation Screw must be cleaned and lubricated every 6
months to maintain proper operation of the treadmill. Failure to
perform this maintenance function will result in premature wear
and ultimate failure of the lift mechanism.
This procedure requires the following tools:
 Service Grease, GE part number 2097829-072
 Clean, lint-free cloth
 Small paint brush
1.
2.
3.
4.
5.

Running Deck Maintenance

The treadmill's running deck is maintenance–free and offers two
running deck surfaces for double the life of ordinary treadmills.
NOTE:
2097937-001 Rev E
12 June 2017
Raise the treadmill to its maximum elevation.
Turn the main power switch to the OFF position, and unplug
the treadmill from its outlet.
Using a lint-free cloth, remove the old lubricant and
accumulated dust from the elevation screw.
Use a small brush to reapply a thin coat of grease to the
threads of the elevation screw. Do not use too much grease—
the excess could squeeze onto the floor and create a slip-and-
fall hazard.
Return the unit to service.
Do not use any silicone or lubricating sprays to wax your
treadmill deck. Using such sprays may void the warranty.
Using such sprays can bring about surface changes that may
result in hesitation or excessive belt slip.
If the running deck surface becomes grooved due to wear, it
can be renewed by flipping the deck to the opposite side, in
the Preventive Maintenance chapter of the T2100-ST1 /
T2100-ST2 Field Service Manual. Your in-house biomedical
technician, or contact GE Medical Systems Information
Technologies and open a customer-billable service call.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Preventive Maintenance
43