Fault 103: Starter/Generator Temperature Sensor Failure - Toro Greensmaster TriFlex 3300 Manual

Hide thumbs Also See for Greensmaster TriFlex 3300:
Table of Contents

Advertisement

Fault 103: Starter/Generator Temperature
Sensor Failure
InfoCenter Display:
Fault Description
This fault is reported when the temperature sensors in the starter/generator (S/G) for the FET and the motor fail.
Circuit Description
There are three internal temperature sensors in the starter/generator (S/G): FET temperature, motor
temperature, and logic board temperature.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1.
Clear the system faults from the InfoCenter. Refer to
2.
Operate the machine.
Pass
The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail
The fault repeated. Go to Step 2.
Step 2: Remove the S/G assembly from the machine.
Remove the S/G assembly from the machine. Refer to Chapter 6 of the 3320/3420 Service Manual. Use the
Removal procedure in either the Generator Assembly (Greensmaster 3320) section or the Generator Assembly
(Greensmaster 3420), depending on your machine.
Step 3: Install a replacement S/G assembly.
Install a replacement S/G assembly into the machine. Refer to Chapter 6 of the 3320/3420 Service Manual.
Use the Installation procedure in either the Generator Assembly (Greensmaster 3320) section or the Generator
Assembly (Greensmaster 3420), depending on your machine.
Step 4: Use Toro DIAG to program the S/G.
1.
Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to
Toro DIAG–Quick Start (page
2.
Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement S/G controller is programmed during the reprogramming of the machine.
3.
Once programming is complete, disconnect the Toro DIAG cable from the machine.
4.
Go to
Returning the Machine to Service (page 21)
_____FAULT
#103____
-
SENSOR
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 21)
22).
and follow the steps listed.
259
19).
and follow the steps listed.

Advertisement

Table of Contents
loading

Table of Contents