Clearing Faults From The Infocenter - Toro Greensmaster TriFlex 3300 Manual

You can read faults 2 ways: on the InfoCenter display
8). This section focuses on the InfoCenter display.
1. Indicator light
2. Right button: press it to open a menu when a right arrow
indicates additional content.
If an electrical fault occurs, the InfoCenter fault indicator light flashes and a fault code number appears on
the display.
•
Faults that are currently happening are called active faults. As soon as a fault occurs, the fault number is
displayed on the InfoCenter. Faults remain active on the screen until you clear them or until the condition
that created the fault no longer exists.
•
Use the InfoCenter Faults screen to see a list of faults that occurred before the most recent starting of the
machine. The Faults screen lists all of the machine faults that have occurred since the InfoCenter fault log
was last cleared.

Clearing Faults from the InfoCenter

Note:
You can clear system faults from the InfoCenter if you have the PIN number to access the proper menu
item. The complete fault history is retained in the TEC-5001 memory and can be viewed via Toro DIAG software.
Entering the PIN code
1. Press the left button as needed to display the Main Menu.
2. From the Main Menu, press the middle button as needed to highlight Settings.
3. Press the right button to display the Settings menu.
4. Press the middle button as needed to highlight Protected Menus.
5. Press the right button. The Enter PIN screen appears.
6. Press the middle button to change the numeric values, and the right button to select each digit.
7. When the PIN entry is complete, press the right button to enter the code.
8. If the code is correct, a check-mark icon appears at the bottom/center of the InfoCenter display screen.
9. Press the middle button once to return to the Settings menu. If the correct PIN was entered, the
InfoCenter screen displays "PIN" in the upper right corner of the screen.
Note:
The PIN stays active until the key is turned O
after the machine has been turned off, you will need to reenter the PIN.
(Figure 6) or on a PC using
Figure 6
3. Middle button: press it to scroll down the menus or digits for
the PIN code.
4. Left button (menu access/back button): press it to access
the InfoCenter menus. Also use it to back out of any menu
that you are currently using.
. If you need to access the Protected Menus again
FF
19
Toro DIAG Software (page
g020650