Separating The Generator Cooling-Air Shrouds; Assembling The Generator Cooling-Air Shrouds - Toro Reelmaster 5010-H Operator's Manual

Separating the Generator
Cooling-Air Shrouds
1. Remove the 4 flange-head capscrews and 4
flange locknuts that secure the upper and lower
generator cooling-air shrouds
Figure 66
1. Flange-head capscrew
2. Upper generator
cooling-air shroud
2. Separate the shrouds.
3. Lift the upper shroud to access the grease
fittings of the driveshaft.
Assembling the Generator
Cooling-Air Shrouds
1. Align the grooves in the top and bottom generator
cooling-air shrouds with the driveshaft-brush
seal and the flange of the generator cover
(Figure 67).
(Figure 66).
g378913
3. Flange locknut
4. Lower generator
cooling-air shroud
1. Upper generator
cooling-air shroud
2. Driveshaft-brush seal
2. Align the holes in the generator cooling-air
shrouds with the compression-limiting pins.
3. Secure the halves of the generator cooling-air
shrouds and compression-limiting pins with the
4 flange-head capscrews and 4 flange locknuts
(Figure 68).
45
Figure 67
3. Flange (generator cover)
4. Lower generator
cooling-air shroud
g378915