Toro Greensmaster TriFlex 3300 Manual page 327

3. Lift the InfoCenter out of the console.
4. Insert the replacement InfoCenter into the console.
5. Secure the InfoCenter with the retaining ring.
6. Plug connector P56 into the InfoCenter.
Step 7: Use Toro DIAG to program the InfoCenter.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement InfoCenter is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Go to Returning the Machine to Service (page 21)
22).
and follow the steps listed.
327