Toro Greensmaster TriFlex 3300 Manual page 112

1. Cutting unit 1 (center), which includes reel motor 1
2. Cutting unit 2 (left), which includes reel motor 2
2. Verify that the cutting units are disconnected from the 48 V power system (the cutting unit power
connectors are separated). This prevents unexpected operation of cutting units. Refer to
Disconnecting the 48 V Power to the Cutting Reel Motors (page
3. Swap cutting reel motor 1 with a cutting reel motor from a different cutting unit. You can obtain more
information on replacing the cutting reel motor in Chapter 5 of the Greensmaster TriFlex 3320/3420
Service Manual
4. Connect the cutting units to the 48 V power system by plugging the cutting unit power connectors together.
Refer to Connecting and Disconnecting the 48 V Power to the Cutting Reel Motors (page
5. Operate the machine.
The fault moves to the
new position.
The fault stopped
repeating.
Step 11: Use Toro DIAG to program the replacement cutting reel
motor.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Install the left-hand cover assembly.
5. Go to Returning the Machine to Service (page 21)
Figure 71
If the fault follows the cutting reel motor to the new cutting unit, replace the cutting
reel motor. Go to Step 11.
If the fault no longer repeats, note the position change of the cutting reel motor in
the maintenance records for the machine. Should the fault repeat in the future,
troubleshooting may be resumed where you left off. Go to
to Service (page 21) and follow the steps listed.
22).
3. Cutting unit 3 (right), which includes reel motor 3
18).
and follow the steps listed.
112
g225145
Connecting and
18).
Returning the Machine