Toro Greensmaster TriFlex 3300 Manual page 297

1. Cutting unit 1 (center), which includes reel motor 1
2. Cutting unit 2 (left), which includes reel motor 2
3. Swap cutting reel motor 2 with a cutting reel motor from a different cutting unit. Refer to the Greensmaster
TriFlex 3320/3420 Service Manual, Chapter 6, Service and Repairs section, Cutting Reel Motor.
4. Connect the 48 V power to the cutting reel motors. Refer to
to the Cutting Reel Motors (page
5. Operate the machine.
The fault moves to the
new position.
The fault stopped
repeating.
Step 3: Use Toro DIAG to program the replacement cutting reel motor.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Install the left-hand cover assembly.
5. Go to Returning the Machine to Service (page 21)
Figure 165
18).
If the fault follows the cutting reel motor to the new cutting unit, replace the
cutting reel motor. Go to Step 3.
If the fault no longer repeats, note the position change of the cutting reel motor
in the maintenance records for the machine. Should the fault repeat in the
future, troubleshooting may be resumed where you left off. Go to
Machine to Service (page 21)
22).
3. Cutting unit 3 (right), which includes reel motor 3
Connecting and Disconnecting the 48 V Power
and follow the steps listed.
and follow the steps listed.
297
g225145
Returning the