Toro Greensmaster TriFlex 3300 Manual page 305

Step 3: Install a replacement controller onto the starter/generator.
Install a replacement controller onto the S/G. Refer to Chapter 6 of the Greensmaster TriFlex 3320/3420 Service
Manual. Use the applicable parts of the Generator Assembly Service section.
Step 4: Install the S/G assembly.
Install the S/G assembly back into the machine. Refer to Chapter 6 of the Greensmaster TriFlex 3320/3420
Service Manual. Use the Installation procedure in either the Generator Assembly (Greensmaster 3320) section
or the Generator Assembly (Greensmaster 3420), depending on your machine.
Step 5: Use Toro DIAG to program the S/G.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement S/G controller is programmed during the reprogramming of the machine.
3. Once programming is complete, disconnect the Toro DIAG cable from the machine.
4. Go to Returning the Machine to Service (page 21)
Pass
The fault is no longer present. Go to
steps listed.
Fail The fault still reports. Repeat the diagnostic process.
22).
and follow the steps listed.
Returning the Machine to Service (page 21)
305
and follow the