Toro Greensmaster TriFlex 3300 Manual page 110

1. Disconnect 48 V power from the cutting units by separating the cutting unit power connectors. This
prevents unexpected operation of cutting units. Refer to
to the Cutting Reel Motors (page
2. Locate the e-reels harness connector P09 near the rear tire of the machine.
1. Rear tire
2. Rear fork base
3. Locate the e-reels harness connectors P17 and P18.
4. Use a multimeter to test the resistance between the following pairs of locations:
Location Harness
1 Main
2 Main
18).
g234786
Figure 69
3. Hydraulic steering
cylinder assembly
Connector Pin
P18 1
P09 3
Connecting and Disconnecting the 48 V Power
1. E-reels harness connector
P09
2. Rear fork base
Wire Expected
Color Reading
Red (R)
Less than
2 ohms
Red (R)
110
g234787
Figure 70
3. Hydraulic steering
cylinder assembly
Connector Graphic