Toro Greensmaster TriFlex 3300 Manual page 40

The fault moves to the
new position.
The fault repeats at the
original position.
The fault stopped
repeating.
Step 4: Use Toro DIAG to program the replacement cutting reel motor.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Install the left-hand cover assembly.
5. Go to Returning the Machine to Service (page 21)
If the fault follows the cutting reel motor to the new cutting unit, replace the
cutting reel motor. Go to Step 4.
If the fault repeats at the cutting unit 3 position, contact the Toro Technical
Assistance Center for additional guidance.
If the fault no longer repeats, note the position change of the cutting reel motor
in the maintenance records for the machine. Should the fault repeat in the
future, troubleshooting may be resumed where you left off. Go to
Machine to Service (page 21)
22).
and follow the steps listed.
and follow the steps listed.
40
Returning the