Hide thumbs Also See for Greensmaster 3300:

Advertisement

Quick Links

Tri-Roller
Greensmaster
Model No. 04722—Serial No. 403370001 and Up
Introduction
This product complies with all relevant European
directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
This roller is designed for maintaining turf on greens
and small fairways of golf courses. Using this product
for purposes other than its intended use could prove
dangerous to you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an authorized Toro
distributor and have the model and serial numbers of
your product ready. The model and serial numbers
are located on a plate on the rear frame. Write the
numbers in the space provided.
Important:
With your mobile device, you can
scan the QR code (if equipped) on the serial
number decal to access warranty, parts, and other
product information.
1. Model and serial number location
© 2022—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3300/3400 Series TriFlex
Figure 1
Register at www.Toro.com.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
g279029
Original Instructions (EN)
Form No. 3457-320 Rev A
®
Traction Unit
Operator's Manual
Figure 2
Safety-alert symbol
*3457-320*
Printed in the USA
All Rights Reserved
g000502

Advertisement

Table of Contents
loading

Summary of Contents for Toro Greensmaster 3300

  • Page 1 Note emphasizes general information a dealer, or to register your product. worthy of special attention. Whenever you need service, genuine Toro parts, or additional information, contact an authorized Toro distributor and have the model and serial numbers of your product ready.
  • Page 2: General Safety

    Make all necessary repairs before resuming operation. • Keep all parts in good working condition and all hardware tightened. Replace all worn or damaged decals. • Use only accessories, attachments, and replacement parts approved by Toro.
  • Page 3 g018312 Figure 4 1. Suspension-arm bar 2. Tri-roller unit bar Close the latches down and around the tri-roller unit and lock them in place (Figure Note: You will hear and feel a “click” when the latches are properly locked in place. Insert the motor into the left side of the tri-roller unit (as viewed from the operator’s position) and pull the motor retaining bar on the tri-roller unit...
  • Page 4: Adding Rear Weight

    Move the motor to the storage location on the Note: These spacers are not included with this front of the suspension arm. kit; order Toro Part No. 63-8410. Note: Do not raise the suspension to the Install the hybrid auxiliary weight provided with transport position when the reel motors are in the traction unit with the provided bolts.
  • Page 5: Preparing For Maintenance

    Maintenance Preparing for Maintenance Before starting on any maintenance procedure, do the following: Park the machine on a level surface. Lower the roller units fully to the ground so that the suspension hydraulics are fully extended. Engage the parking brake, shut off the engine, and remove the key.
  • Page 6 Notes:...
  • Page 7 Notes:...
  • Page 8 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
  • Page 9 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Regulations.
  • Page 10 The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer. Toro uses this information to fulfil contractual obligations - such as to register your warranty, process your warranty claim or to contact you in the event of a product recall - and for legitimate business purposes - such as to gauge customer satisfaction, improve our products or provide you with product information which may be of interest.
  • Page 11 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact your Authorized Toro Service Center.

This manual is also suitable for:

Greensmaster 3400

Table of Contents