Toro Greensmaster TriFlex 3300 Manual page 279

4. Connect the cutting units to the 48 V power system by plugging the cutting unit power connectors together.
Refer to Connecting and Disconnecting the 48 V Power to the Cutting Reel Motors (page
5. Operate the machine.
The fault moves to the
new position.
The fault stopped
repeating.
Step 6: Use Toro DIAG to program the replacement cutting reel motor.
1. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG–Quick Start (page
2. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
3. Disconnect the Toro DIAG cable from the machine.
4. Install the left-hand cover assembly.
5. Go to Returning the Machine to Service (page 21)
If the fault follows the cutting reel motor to the new cutting unit, replace the cutting
reel motor. Go to Step 6.
If the fault no longer repeats, note the position change of the cutting reel motor in
the maintenance records for the machine. Should the fault repeat in the future,
troubleshooting may be resumed where you left off. Go to
to Service (page 21) and follow the steps listed.
22).
and follow the steps listed.
279
18).
Returning the Machine