23.2 Specifications
➠
23.2.1
System configuration
This section describes the system configuration of the drive recorder.
For connection type settings and precautions regarding the communication unit, cable, and connection type, refer to the
following.
➠
■1. Target controller
The drive recorder supports the following servo amplifiers.
Servo amplifier
MELSERVO-J4
MELSERVO-JE
Connect a target servo amplifier to the GOT through a motion controller CPU or a simple motion module.
(1) Applicable motion controller CPUs and simple motion modules
Motion controller CPU and simple motion module
Motion controller CPU(MELSEC iQ-R Series)
Motion controller CPU(Q Series)
Simple motion module
■2. Connection type
Servo amplifier
When a servo amplifier is connected to the GOT through a motion controller CPU (Q series), use a connection type
other than the CC-Link IE Field Network connection between the CPU and the GOT.
For the connection method, refer to the following.
➠
23 - 2
23.2 Specifications
23.2.1 System configuration
23.2.2 Access range
23.2.3 Precautions
GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1
Servo amplifier
SSCNETⅢ/H
GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1
MR-J4-□B, MR-J4-□B-RJ
MR-JE-□B
R16MTCPU, R32MTCPU, R64MTCPU
Q172DSCPU, Q173DSCPU, Q170MSCPU, Q170MSCPU-S1
RD77MS2, RD77MS4, RD77MS8, RD77MS16,
FX5-40SSC-S,
QD77MS2, QD77MS4, QD77MS16,
LD77MS2, LD77MS4, LD77MS16
Motion controller
CPU, or PLC CPU
Varies according to the connection type.
Model
Model
GOT