Searching Commands And Devices - Mitsubishi Electric GOT2000 Series User Manual

15.4.4

Searching commands and devices

Displays a command or device by searching it in sequence program from Step 0.
■1. Command search
(1) Operation
MODE
(Read mode)
*1 If the command you want to search for is not on the keyboard, touch the [MORE] key to switch to the other keyboard.
When searching for an applied instruction, touch the [FNC] key and input the applied instruction number.
When searching for a label, touch [P] or [I] and input the pointer number.
➠
*2 Input only when searching for commands requiring a device name and device number.
*3 After the search results are displayed, you can continue searching with the same conditions by touching the [GO] key.
Touching any key other than the [GO] key ends the search.
(2) Example
Searching for LD M8000
ChNo.[1]
MODE
ChNo.[1]
LD
*1
Select the command
to search for.
15.4.5 ■2. Writing applied instructions
< WRITE >
Set the
< READ >
READ mode.
( )
Select the command
to search for.
POINT POINT POINT
Pointer (P, I) searches
For pointer searches, only labels are searched.
Pointers specified as operands in applied instructions are not searched.
*2
Input the device name and
device number.
Search command
LD
3 MOV
M 8
8 LD M
9 OUT T
K
12 LD
(Continue to search with the
GO
same conditions)
24 LD
25 OUT T
K
28 OUT T
15.4 Operation Procedures
*3
GO GO
12
0 0 0 GO
8000
10
100
X 002
M 8000
0
100
1
15
15 - 13