Mitsubishi Electric GOT2000 Series User Manual page 60

■2. Displaying the device monitor screen for the second time and later
Follow the procedure described below to display the device monitor screen.
Step 1.
Start the device monitor.
The following three methods are provided for starting the device monitor.
• Using the special function switch (device monitor) set for the project
Touch the special function switch (device monitor) placed on the monitor screen.
For the setting method of the special function switch, refer to the following.
➠
If the project has not been written into the GOT yet, start the device monitor from the Utility.
• Starting the device monitor from the utility
Display the utility screen and select the [Monitor] tab and [Device Monitor].
For the display method of the utility, refer to the following.
➠
• Touching [Device monitor] on the [MELSEC-L troubleshooting screen
When [MELSEC-L troubleshooting] is used, touch the [Device monitor] button.
➠
Step 2.
The [History] dialog appears.
Select the monitor history to be recovered and touch the [OK] key.
If you want to change the monitor target, touch the [Cancel] button.
The communication setting dialog appears.
Select the connection destination and communication driver of the controller to be monitored.
➠
Step 3.
The [Device monitor] screen appears.
3 - 16
3.3 Operations Common to the Monitor Screens
GT Designer3 (GOT2000) Screen Design Manual
GOT2000 Series User's Manual (Utility)
11. MELSEC-L TROUBLESHOOTING
3.3.4 ■2. Communication setting dialog