Setup - Mitsubishi Electric GOT2000 Series User Manual

5) [Parameters] key
Displays the parameter data and changes the parameter settings.
➠
9.4.6 Parameter setting
6) [Test ]
Performs various test operations (JOG operation, positioning operation, motor-less operation and DO forced
output).
➠
9.4.7 Test operations
9.4.2

Setup

This is used to set the communication with the servo amplifier.
Before making the settings on the setup screen, also make the same settings on the servo amplifier side.
If the settings on this screen and the settings on the servo amplifier do not match, proper communications may not be
performed.
The settings on the setup screen return to the initial state when the GOT is turned off or reset.
After turning on the power to the GOT, perform the settings on the setup screen again.
■1. Setup screen
This section describes the display data of the setup screen and the key functions displayed on the screen.
(1) Displayed contents
[Axis number] and [Capacity setting] cannot be set.
1) [Model]
Displays the model of the servo amplifier to be connected.
2) [Station]
Displays the station number (00 to 31) of the servo amplifier to communicate with.
3) [IFU Station]
Displays the serial communication station number of the IFU (interface unit).
1)
2)
3)
9.4 Operations of Servo Amplifier Monitor Screens
9
9 - 11