Access Range - Mitsubishi Electric GOT2000 Series User Manual

■5. Required memory space for use of the intelligent module monitor
To check the required memory space for use of the intelligent module monitor, refer to the following.
➠
The memory space required for storing data into the internal memory of the GOT is the same as the memory space
required for storing data into the hard disk of a personal computer.
8.2.2

Access range

■1. When using the bus connection, direct CPU connection, or serial communication
connection
• The intelligent module monitor can monitor intelligent function modules on the bases of the connected station and
other stations.
• In the serial communication connection, the intelligent module monitor is available only for the systems that use the
following combinations.
PLC CPU used
QCPU (Q mode)
LCPU
*1
• The following restrictions apply when monitoring other stations of MELSECNET/II data link systems.
Only the host and master stations can be monitored when the connected station is a local station.
Regardless of the type of connected station, no stations other than ACPU can be monitored.
• When connected to a remote I/O station on the MELSECNET/H network system, the remote I/O station on the
MELSECNET/H network system is displayed as QCPU in the system configuration display of the intelligent module
monitor.
• A diagnosis of the remote I/O station on the MELSECNET/H network system is not performed.
• Intelligent function modules on the base of remote I/O stations other than those on the MELSECNET/H network
system are not monitored.
■2. When using MELSECNET/H, MELSECNET/10, or CC-Link IE controller network connection
• The intelligent module monitor can monitor intelligent function modules on the bases of the control station and
normal stations.
• To monitor another network, routing parameters have to be set to the GOT side and PLC side.
(Only with the MELSECNET/H communication unit or CC-Link IE controller network communication unit)
For the routing parameter setting, refer to the following.
Routing parameter setting for the GOT
➠
Routing parameter setting for PLC CPU
• For MELSECNET/H communication unit
➠
• For CC-Link IE controller network communication unit
➠
■3. When using CC-Link IE field network connection
The intelligent module monitor can monitor intelligent function modules on the bases of the master station and local
stations.
To monitor another network, routing parameters have to be set to the GOT side and PLC side.
For the routing parameter setting, refer to the following.
Routing parameter setting for the GOT
➠
Routing parameter setting for PLC CPU
➠
■4. When using CC-Link connection (Intelligent device station/via G4)
The intelligent module monitor can monitor intelligent function modules on the bases of the master station and local
stations.
8 - 4
8.2 Specifications
GT Designer3 (GOT2000) Screen Design Manual
QJ71C24
LJ71C24, LJ71C24-R2
For details of module names, refer to the GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1.
GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1
Q Corresponding MELSECNET/H Network System Reference Manual (PLC to PLC network)
CC-Link IE Controller Network Reference Manual
GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1
The User's Manual of the CC-Link IE field network system master/local module to be used
Serial communication module used
*1