Mitsubishi Electric GOT2000 Series User Manual page 243

Step 2.
The following window appears after the channel No. is selected.
Set the network number of the target controller and the CPU station number.
Step 3.
After selecting the station number, touch the [Enter] key. The communication setting window closes and the
system configuration of the set monitor destination is displayed.
■1. Communication setting window
(1) Displayed screen
3) 1)
When the CH No. is input
1) CH No. input area
Set the CH No. for the target controller.
The setting range is [1] to [4].
2) Network No. input area
Set the network No. for the target controller.
The following shows the setting ranges.
• Bus connection, direct CPU connection, and serial communication connection: [0]
• Ethernet connection and CC-Link IE Controller Network connection: [1] to [239]
• MELSECNET/H, MELSECNET/10: [0] (Host loop) or [1] to [255] (Specified loop)
• CC-Link (ID/G4) connection: [0]
3) Station No. input area
Set the station No. of the target controller.
When the station No. is set to the host station (FF), set the network No. to 0.
The following shows the setting ranges.
• Bus connection, direct CPU connection, and serial communication connection: [FF] (Host station)
• Ethernet connection: [1] to [64]
• MELSECNET/H connection and MELSECNET/10 connection: [0] (Control station) or [1] to [64] (Local
station)
• CC-Link IE Controller Network connection: [1] to [120]
• CC-Link (ID/G4) connection: [0] (Master station) or [1] to [64] (Local station)
4) CH No. selection key
Select a CH No.
5) Keys
The keys used for the operations in the communication setting window.
2)
4)
3) 1) 2)
When the network No., station No.,
and CPU No. are input
7.4 Operation Procedures
7
5)
7 - 11