Facility Circuit Breaker Trips When Powering Up - GE T2100-ST1 Operator's Manual

Troubleshooting

Facility Circuit Breaker Trips when Powering Up

If the main circuit breaker trips when the treadmill is first turned on,
the main circuit that the treadmill is on may be overloaded. This will
happen even if the treadmill is on a proper, dedicated line. Refer this
problem to your local electrician and check that the service panel
circuit breaker is a high magnetic breaker.
Treadmill Will Not Start
1. Make sure the Emergency Stop Button is released.
2. Make sure the Safety Lanyard clip is connected to the switch.
Running Belt Slips When In Use
Over a period of time, the treadmill running belt will stretch and
allow slippage when used by a heavy person. See "Final Setup -
Running Belt Tension Adjustment" on page 31 to adjust.
Running Belt Is Off-Center
Occasionally the treadmill running belt will become off-center. See
"Final Setup - Running Belt Tracking Adjustment" on page 30 to
adjust.
Internal Circuit Breaker Location and Resetting
All circuit breakers are located at the front of the treadmill and
below the hood.
 2 ea. Power Supply / Relay Board (1/4 amp)
 2 ea. Elevation Motor (3 amp [110v or 220v])
To reset a breaker, push the button.
NOTE:
46
Contact GE Medical Systems Information Technologies, Inc., for
information on possible causes of tripped circuit breakers.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-001 Rev E
12 June 2017