Cisco ONS 15454 SDH Configuration Manual page 550

show rpr-ieee topology detail
show rpr-ieee topology detail
Use this command to display topology information gathered by the station from the protection and ATD
messages received on either span of an IEEE 802.17b based RPR ring.
Syntax Description This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged exec
Usage Guidelines
Use this command to obtain an extremely detailed status of the ring, including details about each
station's configuration.
Examples
router# show rpr-ieee topology detail
802.17 Topology Display
RX ringlet0->West spanRX ringlet1->East span
Number of nodes on
=======================================================================
Local Station Topology Info
=======================================================================
Topology entry:
Station MAC address: 0005.9a3c.59c0
West Span (Outer ringlet RX) neighbor 000b.fcff.9d34
East Span (Inner ringlet RX) neighbor 0013.1991.1fc0
Ring Topology: CLOSED (STABLE)
Containment Active: NO
A0 class reserved rate:
Ringlet reserved rate:
Ringlet unreserved rate:
Ringlet effective unreserved rate:
Advertised Protection requests:
Active Edges:
Configured protection mode: STEERING
Jumbo preference: NOT SET (ring doesn't support JUMBOS)
Is revertive: YES
Measured LRTT: 0
Sequence Number: 3
ATD INFO:
ATD timer: 1 sec
Station Name: ML100T-481
A0 reserved Bandwidth:
SAS enabled: YES
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-74
ringlet0: 5ringlet1: 5
ringlet0: 0 (mbps)ringlet1: 0 (mbps)
ringlet0: 0 (mbps)ringlet1: 0 (mbps)
ringlet0: 96 (mbps)ringlet1: 96 (mbps)
ringlet0: 95.9 (mbps)ringlet1: 95.9 (mbps)
ringlet0: IDLEringlet1: IDLE
ringlet0: NO ringlet1: NO
ringlet0: 0 mbpsringlet1: 0 mbps
Appendix A Command Reference