Vc Type 5 Configuration On Pe-Cle Port - Cisco ONS 15454 SDH Configuration Manual

VC Type 5 Configuration on PE-CLE Port

Command
Step 7
Router(config-subif)# mpls l2transport route
destination vc-id
or
xconnect destination vc-id encapsulation mpls
Step 8
Router(config-subif)# end
Step 9
Router# show mpls l2transport vc
Step 10
Router# copy running-config startup-config
VC Type 5 Configuration on PE-CLE Port
The customer-facing FastEthernet or GigabitEthernet port must be provisioned with EoMPLS and a
VC type 4 or type 5. Interface GigE 1 on card A and card C plays the VC type 5 role in
page
on page
To provision a VC type 5, which transports the configured port's packets between two PE-CLE
ML-Series cards, perform the following procedure on the customer facing port, beginning in global
configuration mode:
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
18-6
18-10. For more information on the role of a VC type 5, see the
18-1.
Chapter 18 Configuring Ethernet over MPLS
Purpose
By entering the mpls l2transport route or the xconnect
interface configuration command on a dot1Q VLAN
sub-interface for VLAN-based EoMPLS, you can
configure an EoMPLS tunnel to forward traffic based on
the customer VLAN.
mpls l2transport route specifies the VC to use to
transport the VLAN packets. Initiates a remote LDP
session with the peer point-to-point endpoint interface.
• destination specifies the loopback IP address for the
remote ML-Series at the other end of the VC
(PE-CLE).
vc-id is a value you supply. It must be unique for
•
each VC. The VC ID is used to connect the
endpoints of the VC. Specify the same VC ID on
both ends of the VC.
xconnect binds the 802.1q VLAN circuit to a pseudo
wire for xconnect service. The encapsulation mpls
pseudo wire class parameter specifies MPLS for the
tunneling method.
The xconnect command is a newer version of the
Note
mpls l2transport route interface configuration
command.
Use the no mpls l2transport route destination
Note
vc-id or no xconnect destination vc-id
encapsulation mpls interface command to
delete the EoMPLS tunnel.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file
"Understanding EoMPLS" section
Figure 18-2 on