Chapter 3 Initial Configuration - Cisco ONS 15454 SDH Configuration Manual

Cisco IOS on the ML-Series Card
Cisco IOS on the ML-Series Card
The Cisco IOS software image used by the ML-Series card is not permanently stored on the ML-Series
card but in the flash memory of the TCC2/TCC2P card. During a hard reset, when a card is physically
removed and reinserted or power is otherwise lost to the card, the Cisco IOS software image is downloaded
from the flash memory of the TCC2/TCC2P to the memory cache of the ML-Series card. The cached
image is then decompressed and initialized for use by the ML-Series card.
During a soft reset, when the ML-Series card is reset through CTC or the Cisco IOS command line
interface (CLI) command reload, the ML-Series card checks its cache for a Cisco IOS image. If a valid
and current Cisco IOS image exists, the ML-Series card decompresses and initializes the image. If the
image does not exist, the ML-Series requests a new copy of the Cisco IOS image from the TCC2/TCC2P.
Caching the Cisco IOS image provides a significant time savings when a warm reset is performed.
There are four ways to access the ML-Series card Cisco IOS configuration. The two out-of-band options
are opening a Cisco IOS session on CTC and telnetting to the node IP address and slot number plus 2000.
The two-in-band signalling options are telnetting to a configured management interface and directly
connecting to the console port.
Opening a Cisco IOS Session Using CTC
Users can initiate a Cisco IOS CLI session for the ML-Series card using CTC. Click the IOS tab at the
card-level CTC view, then click the Open IOS Command Line Interface (CLI) button
window opens and a standard Cisco IOS CLI user EXEC command mode prompt appears.
A Cisco IOS startup configuration file must be loaded and the ML-Series card must be installed and
Note
initialized prior to opening a Cisco IOS CLI session on CTC. See the
section on page 3-7
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
3-2
for more information.

Chapter 3 Initial Configuration

(Figure 3-1). A
"Startup Configuration File"