Deleting An Ml-Series Card From A Cisco Proprietary Rpr - Cisco ONS 15454 SDH Configuration Manual

Deleting an ML-Series Card from a Cisco Proprietary RPR

The specific steps in the following procedure are for the topology in the example. Your own steps will
Caution
vary according to your network design. Do not attempt this procedure without obtaining a detailed plan
or method of procedure from an experienced network architect.
Deleting an ML-Series Card from a Cisco Proprietary RPR
To
delete an ML-Series card from a Cisco proprietary RPR, complete the following procedure:
Start a Cisco IOS CLI session for the ML-Series card on the first adjacent node. This is Adjacent Node 1
Step 1
in Figure
Complete the following Cisco IOS configuration on the ML-Series card in the first adjacent node,
Step 2
beginning in global configuration mode:
a. Router(config)# interface pos
interface-number
b.
Router(config-if)# shutdown
Step 3 Start a Cisco IOS CLI session for the ML-Series card in Adjacent Node 2, as shown in
Complete the following Cisco IOS configuration on the Adjacent Node 2 ML-Series card, beginning in
Step 4
global configuration mode:
a. Router(config)# interface pos
interface-number
b. Router(config-if)# shutdown
Log into Adjacent Node 1 with CTC.
Step 5
Double-click the ML-Series card in Adjacent Node 1.
Step 6
The card view appears.
Click the Circuits tab.
Step 7
Click the Circuits subtab.
Step 8
Identify the appropriate STS circuit by looking under the source column and destination column for the
Step 9
circuit entry that matches the POS ports at the endpoints of the first circuit to be deleted.
The circuit entry is in node-name/card-slot/port-number format, such as Node-1/s12(ML100T)/pPOS-0.
Click the circuit entry to highlight it.
Step 10
Click Delete.
Step 11
A confirmation dialog box appears.
Step 12 Click Yes.
Step 13 Verify that Ethernet connectivity still exists between the Ethernet access ports on Adjacent Node 1 and
Adjacent Node 2 by using a test set.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
17-26
17-11.
Chapter 17 Configuring Cisco Proprietary Resilient Packet Ring
Enters interface configuration mode for the POS port at the
end of the circuit directly connected to the Delete Node.
Closes the interface, which initiates the Cisco proprietary
RPR wrap.
Enters interface configuration mode for the POS port at the
end of the circuit directly connected to the Delete Node.
Closes the interface.
Figure 17-11.