Chapter 14 Configuring Quality of Service
Table 14-2
Traffic Policy Commands (continued)
Command
Router (config-pmap-c)# police cir-rate-bps
normal-burst-byte [ max-burst-byte ] [ pir
pir-rate-bps ] [conform-action {set-cos-transmit |
transmit | drop}] [exceed-action {set-cos-transmit
| drop}] [violate-action {set-cos-transmit | drop}]
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Purpose
Defines a policer for the currently selected class when the
policy map is applied to input. Policing is supported only on
ingress, not on egress.
•
For cir-rate-bps, specify the average committed
information rate (cir) in bits per second (bps). The range is
96000 to 800000000.
For normal-burst-byte, specify the cir burst size in bytes.
•
The range is 8000 to 64000.
(Optional) For maximum-burst-byte, specify the peak
•
information rate (pir) burst in bytes. The range is 8000 to
64000.
(Optional) For pir-rate-bps, specify the average pir traffic
•
rate in bps where the range is 96000 to 800000000.
(Optional) Conform action options are:
•
Set a CoS priority value and transmit
–
Transmit packet (default)
–
Drop packet
–
(Optional) Exceed action options are:
•
Set a CoS value and transmit
–
Drop packet (default)
–
(Optional) The violate action is only valid if pir is
•
configured. Violate action options are:
Set a CoS value and transmit
–
Drop packet (default)
–
Creating a Traffic Policy
14-15