Cisco ONS 15454 SDH Configuration Manual page 163

Chapter 10 Configuring Link Aggregation
Step 3
Router(config-if)# lacp port-priority < priority number >
Step 4
Router(config-if)# exit
Configure the LACP system priority. This configuration is optional.
Step 1
Router(config)#lacp system-priority < system priority >
Step 2
Router(config)# exit
Step 3
Router# copy running-config startup-config
In Example
Example 10-8 LACP Configuration Example
#sh running-config interface gigabitEthernet 0
Building configuration...
Current configuration : 150 bytes
!
interface GigabitEthernet0
end
Station-1#sh running-config interface port-channel 5
Building configuration...
Current configuration : 112 bytes
!
interface Port-channel5
end
10-8, an interface is added to a GEC.
no ip address
no keepalive
channel-group 5 mode active
no ip address
bridge-group 101
hold-queue 300 in
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Sets the LACP port's priority. Range of values is
from 1 through 65535. For example,
lacp port-priority 100
Exits the port's configuration mode.
Sets the LACP system priority in a range of values
from 1 through 65535. For example,
lacp system-priority 100
Exits the global configuration mode.
(Optional) Saves the configuration changes to
NVRAM.
Configuring LACP
10-13