Adding An Ml-Series Card Into A Cisco Proprietary Rpr - Cisco ONS 15454 SDH Configuration Manual

Adding an ML-Series Card into a Cisco Proprietary RPR

•
•
The specific steps in the following procedure are for the topology in the example. Your own steps will
Caution
vary according to your network design. Do not attempt this procedure without obtaining a detailed plan
or method of procedure from an experienced network architect.
Adding an ML-Series Card into a Cisco Proprietary RPR
To
add an ML-Series card to the Cisco proprietary RPR in the example, complete the following
procedure:
Start a Cisco IOS CLI session for the ML-Series card in the first adjacent node. This is Adjacent Node 1
Step 1
in Figure
Complete the following Cisco IOS configuration on the ML-Series card in the first adjacent node,
Step 2
beginning in global configuration mode:
a. Router(config)# interface pos
interface-number
b. Router(config-if)# shutdown
Start a Cisco IOS CLI session for the ML-Series card in Adjacent Node 2, as shown in
Step 3
Step 4 Complete the following Cisco IOS configuration on the Adjacent Node 2 ML-Series card, beginning in
global configuration mode:
a. Router(config)# interface pos
interface-number
b. Router(config-if)# shutdown
In CTC, log into Adjacent Node 1.
Step 5
Double-click the ML-Series card in Adjacent Node 1.
Step 6
The card view appears.
Click the Circuits tab.
Step 7
Click the Circuits subtab.
Step 8
Identify the appropriate STS circuit by looking under the source column and destination column for the
Step 9
circuit entry that matches the POS ports at the endpoints of the circuit to be deleted.
The circuit entry is in node-name/card-slot/port-number format, such as Node-1/s12(ML100T)/pPOS-0.
Click the circuit entry to highlight it.
Step 10
Click Delete.
Step 11
A confirmation dialog box appears.
Click Yes.
Step 12
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
17-22
Test Ethernet connectivity between the access ports on the new ML-Series card with a test set to
validate the newly created three-node Cisco proprietary RPR.
Monitor Ethernet traffic and existing routing protocols for at least an hour after the node insertion.
17-9.
Chapter 17 Configuring Cisco Proprietary Resilient Packet Ring
Enters interface configuration mode for the POS port at one
endpoint of the circuit to be deleted.
Closes the interface, which initiates the wrap.
Enters interface configuration mode for the POS port at one
endpoint of the circuit to be deleted.
Closes the interface.
Figure 17-9.