Cisco ONS 15454 SDH Configuration Manual page 81

Chapter 4 Configuring Interfaces
Enter the show controller command to display information about the Fast Ethernet controller chip.
Example 4-9
initialization block information.
Example 4-9
Router# show controller fastEthernet 0
IF Name: FastEthernet0
Port Status DOWN
Send Flow Control
Receive Flow Control : Enabled
MAC registers
CMCR : 0x0000042D (Tx Enabled, Rx Disabled)
CMPR : 0x150B0A80 (Long Frame Disabled)
FCR
MII registers:
Control Register
Status Register
PHY Identification Register 1 (0x2): 0x40
PHY Identification Register 2 (0x3): 0x61D4
Auto Neg. Advertisement Reg
Auto Neg. Partner Ability Reg (0x5): 0x0
Auto Neg. Expansion Register
100Base-X Aux Control Reg
100Base-X Aux Status Register(0x11): 0x0
100Base-X Rcv Error Counter
100Base-X False Carr. Counter(0x13): 0x0
Enter the show run interface [type number] command to display information about the configuration of
the Fast Ethernet interface. The command is useful when there are multiple interfaces and you want to
look at the configuration of a specific interface.
Example 4-10
information about the IP address or lack of IP address and the state of the interface.
Example 4-10 show run interface Command Output
daytona# show run interface FastEthernet 1
Building configuration...
Current configuration : 56 bytes
!
interface FastEthernet1
no ip address
shutdown
end
shows the output from the show controller command, which shows statistics including
show controller Command Output
: Disabled
: 0x0000A00B (Rx Pause detection Enabled)
shows output from the show run interface [type number] command, which includes
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Monitoring Operations on the Fast Ethernet and Gigabit Ethernet Interfaces
(0x0): 0x4000 (Auto negotiation disabled)
(0x1): 0x7809 (Link status Down)
(0x4): 0x1E1 (Speed 100, Duplex Full)
(Speed 10, Duplex Half)
(0x6): 0x4
(0x10): 0x2000
(0x12): 0x0
4-13