Cisco ONS 15454 SDH Configuration Manual page 510

show controller pos interface-number [detail]
show controller pos interface-number [detail]
Use this command to display the status of the POS controller. Use the detail argument to obtain
additional SONET and POS information for the interface.
Syntax Description Parameter
interface-number
Defaults
N/A
Command Modes
Privileged execxecutive
Usage Guidelines This command can be used to help diagnose and isolate POS or SONET problems.
Examples The following example is an example of POS continuous concatenation circuit (CCAT) show controller
output.
Router(config)# show controller pos 0
Router# show controller pos 0
Interface POS0
Hardware is Packet/Ethernet over Sonet
Concatenation: CCAT
Circuit state: IS
PATH
PPLM
BER_SF_B3 = 0
NEWPTR
Active Alarms : None
Demoted Alarms: None
Active Defects: None
Alarms reportable to CLI: PAIS PLOP PUNEQ PTIM PPLM PRDI PPDI BER_SF_B3 BER_SD_B3
VCAT_OOU_TPT LOM SQM
Link state change defects: PAIS PLOP PUNEQ PTIM PPLM PRDI PPDI BER_SF_B3
Link state change time
DOS FPGA channel number
Starting STS (0 based)
VT ID (if any) (0 based) : 255
Circuit size
RDI Mode
C2 (tx / rx)
Framing
Path Trace
Mode
Transmit String :
Expected String :
Received String :
Buffer
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-34
Description
Number of the POS interface (0–1)
PAIS = 0 PLOP
= 0 PUNEQ
BER_SD_B3 = 0
= 0 PSE
: 200 (msec)
: 0
: 0
: VC4
: 1 bit
: 0x01 / 0x01
: SDH
: off
: Stable
= 0 PRDI = 0
= 0 PPDI = 0
BIP(B3) = 20
= 0 NSE = 0
Appendix A Command Reference
PTIM = 0
PTIU = 0
REI = 2