Cisco ONS 15454 SDH Configuration Manual page 507

Appendix A Command Reference
rpr-ieee tx-traffic rate-limit reserved rate [east | west]
Use this command to limit the transmission rate of Class A0 reserved traffic on a specific (east or west)
span.
Syntax Description Parameter
east
west
rate
Defaults
The default is 0 Mbps.
Command Modes
IEEE 802.17b based RPR interface configuration
Usage Guidelines A0 bandwidth is dedicated and cannot be reused for any other traffic, and thus should be assigned
cautiously. This command is specific to one span and would only be used if necessary to make a
distinction.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee tx-traffic rate-limit reserved 5 east
Related Commands
rpr-ieee tx-traffic rate-limit low [rate] {east | west}
rpr-ieee tx-traffic rate-limit medium [rate] {east | west}
rpr-ieee tx-traffic rate-limit high [rate] {east | west}
rpr-ieee tx-traffic rate-limit reserved [rate]
Description
Pertains to configuration for eastbound span traffic.
Pertains to configuration for westbound span traffic.
Value, expressed in Mbps, of the total bandwidth a station can use to
transmit Class A0 traffic onto a particular (east or west) span. Range is 0 to
1161 Mbps.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
rpr-ieee tx-traffic rate-limit reserved rate [east | west]
A-31