Encapsulation Over Etherchannel Example - Cisco ONS 15454 SDH Configuration Manual

Encapsulation over EtherChannel Example

Command
Step 4
Router(config-subif)# end
Step 5
Router# copy running-config startup-config
Encapsulation over EtherChannel Example
Figure 10-3
Example 10-5
Figure 10-3
Fast Ethernet 1
This encapsulation over EtherChannel example shows how to set up two ONS 15454s with ML100T-12
cards (Switch A and Switch B) to interoperate with two switches that also support IEEE 802.1Q
encapsulation over EtherChannel. To set up this example, use the configurations in the following
sections for both Switch A and Switch B.
Example 10-5 Switch A Configuration
hostname Switch A
!
bridge irb
bridge 1 protocol ieee
bridge 2 protocol ieee
!
interface Port-channel1
no ip address
hold-queue 150 in
!
interface Port-channel1.1
encapsulation dot1Q 1 native
bridge-group 1
!
interface Port-channel1.2
encapsulation dot1Q 2
bridge-group 2
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
10-8
shows an example of encapsulation over EtherChannel. The associated code is provided in
(Switch A) and Example 10-6
Encapsulation over EtherChannel Example
POS 0
Fast Ethernet 0
802.1Q Trunking
VLANs 1 & 2
Purpose
Exits to privileged EXEC mode.
Note Optionally, you can remain in interface
configuration mode and enable other
supported interface commands to meet
your requirements.
(Optional) Saves the configuration changes to
NVRAM.
(Switch B).
SONET STS-1 POS 0
Fast Ethernet 0
802.1Q Trunking
VLANs 1 & 2
Chapter 10 Configuring Link Aggregation
Fast Ethernet 1