Configuring Gigabit Ethernet Remote Failure Indication (Rfi) - Cisco ONS 15454 SDH Configuration Manual

Chapter 4 Configuring Interfaces
Command
Step 6
Router(config)# end
Step 7
Router# copy running-config startup-config
Example 4-2
autonegotiation and an IP address.
Example 4-2
Router(config)# interface gigabitethernet 0
Router(config-if)# ip address 10.1.2.3 255.0.0.0
Router(config-if)# negotiation auto
Router(config-if)# no shutdown
Router(config-if)# end
Router# copy running-config startup-config

Configuring Gigabit Ethernet Remote Failure Indication (RFI)

Remote Failure Indication (RFI) is part of the IEEE 802.3z standard and is sent to exchange failure
information as part of link negotiation. This feature improves communication between non-Cisco
equipment and the ML1000-2. RFI is not on by default but can be turned on by the user. Disabling RFI
is sometimes necessary when a non-Cisco piece of equipment does not support the IEEE 802.3z standard
implementation of RFI.
RFI on the ML-Series card supports bidirectional RFI. When there is a a local fault on the ML-Series
card, the ML-Series card will raise a local CARLOSS alarm and send its link partner an RFI. If an
ML-Series card receives an RFI from its link partner, it raises the AUTONEG-RFI alarm and shuts down
the Gigabit Ethernet port.
To enable RFI on a Gigabit Ethernet interface, perform the following procedure, beginning in global
configuration mode:
Command
Step 1
Router (config)# interface gigabitethernet
number
Step 2
Router(config-if)# [no] rfi auto
Step 3
Router(config)# end
Step 4
Router# copy running-config startup-config
Example 4-3
Example 4-3
Router(config)# interface gigabitethernet 0
Router(config-if)# rfi auto
Router(config-if)# end
shows how to do an initial configuration of a Gigabit Ethernet interface with
Initial Configuration of a Gigabit Ethernet Interface
shows how to do an initial configuration of RFI on a Gigabit Ethernet interface.
RFI Configuration of a Gigabit Ethernet Interface
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Configuring Gigabit Ethernet Remote Failure Indication (RFI)
Purpose
Returns to privileged EXEC mode.
(Optional) Saves configuration changes to
TCC2/TCC2P flash database.
Purpose
Activates interface configuration mode to
configure the Gigabit Ethernet interface.
Enables IEEE 802.3z standard RFI.
The no form of the command disables RFI.
Returns to privileged EXEC mode.
(Optional) Saves configuration changes to
TCC2/TCC2P flash database.
4-7