Setting The Agent Contact And Location Information - Cisco ONS 15454 SDH Configuration Manual

Setting the Agent Contact and Location Information

Command
Step 6
snmp-server trap-source interface-id
Step 7
snmp-server queue-length length
Step 8 snmp-server trap-timeout seconds
Step 9
end
Step 10 show running-config
Step 11 copy running-config startup-config
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
inform requests). To enable a host to receive an inform request, you must configure an
snmp-server host informs command for the host and globally enable inform requests by using the
snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
inform requests, to the host. To disable inform requests, use the no snmp-server host informs global
configuration command. To disable a specific trap type, use the no snmp-server enable traps
notification-types global configuration command.
Setting the Agent Contact and Location Information
Beginning in privileged EXEC mode, follow these steps to set the system contact and location of the
SNMP agent so that these descriptions can be accessed through the configuration file:
Command
Step 1 configure terminal
Step 2
snmp-server contact text
Step 3
snmp-server location text
Step 4 end
Step 5 show running-config
Step 6 copy running-config startup-config
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
22-12
Purpose
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
inform requests.
(Optional) Establish how many trap messages each trap host can hold
(message queue length.) The range is 1 to 1000; the default is 10.
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Set the system contact string.
For example:
snmp-server contact Dial System Operator at beeper 21555.
Set the system location string.
For example:
snmp-server location Building 3/Room 222
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 22 Configuring SNMP