Basic Fast Ethernet, Gigabit Ethernet, and POS Interface Configuration
Basic Fast Ethernet, Gigabit Ethernet, and POS Interface
Configuration
ML-Series cards support Fast Ethernet, Gigabit Ethernet, and POS interfaces. This section provides
some examples of configurations for all interface types.
To configure an IP address or bridge-group number on a Fast Ethernet, Gigabit Ethernet, or POS
interface, perform the following procedure, beginning in global configuration mode:
Command
Step 1
Router(config)# interface type number
Step 2
Router(config-if)# {ip address ip-address
subnet-mask | bridge-group
bridge-group-number }
Step 3
Router(config-if)# no shutdown
Step 4
Router(config)# end
Step 5
Router# copy running-config startup-config
Configuring the Fast Ethernet Interfaces for the ML100T-12
To configure the IP address or bridge-group number, speed, duplex, and flow control on an ML100T-12
Fast Ethernet interface, perform the following procedure, beginning in global configuration mode:
Command
Step 1
Router(config)# interface fastethernet
number
Step 2
Router(config-if)# {ip address ip-address
subnet-mask | bridge-group
bridge-group-number }
Step 3
Router(config-if)# [no] speed {10 | 100 |
auto}
Step 4
Router(config-if)# [no] duplex {full
|
auto}
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
4-4
Purpose
Activates interface configuration mode to
configure either the Gigabit Ethernet interface, the
Fast Ethernet interface, or the POS interface.
Sets the IP address and IP subnet mask to be
assigned to the interface.
or
Assigns a network interface to a bridge group.
Enables the interface by preventing it from
shutting down.
Returns to privileged EXEC mode.
(Optional) Saves configuration changes to timing
and control card (TCC2/TCC2P) flash database.
Purpose
Activates interface configuration mode to
configure the Fast Ethernet interface.
Sets the IP address and IP subnet mask to be
assigned to the interface.
or
Assigns a network interface to a bridge group.
Configures the transmission speed for 10 or
100 Mbps. If you set the speed or duplex for auto,
you enable autonegotiation on the system. In this
case, the ML-Series card matches the speed and
duplex mode of the partner node.
|
Sets full duplex, half duplex, or autonegotiate
half
mode.
Chapter 4 Configuring Interfaces