Cisco ONS 15454 SDH Configuration Manual page 42

ML-Series Feature List
• Cisco Proprietary RPR:
–
–
–
–
–
Fast EtherChannel (FEC) features (ML100T-12):
•
–
–
–
–
–
–
• Gigabit EtherChannel (GEC) features (ML1000-2):
–
–
–
–
–
POS channel:
•
–
–
–
–
• Layer 3 routing, switching, and forwarding:
–
–
–
–
–
–
–
–
–
–
–
Supported routing protocols:
•
–
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
1-4
Ethernet frame check sequence (FCS) preservation for customers
Cyclic redundancy check (CRC) error alarm generation
FCS detection and threshold configuration
Shortest path determination
Keep alives
Bundling of up to four Fast Ethernet ports
Load sharing based on source and destination IP addresses of unicast packets
Load sharing for bridge traffic based on MAC addresses
IRB
IEEE 802.1Q trunking
Up to 6 active FEC port channels
Bundling the two Gigabit Ethernet ports
Load sharing for bridge traffic based on MAC addresses
IRB
IEEE 802.1Q trunking
Auto-negotiation with Remote Fault Indication (RFI)
Bundling the two POS ports
LEX encapsulation only
IRB
IEEE 802.1Q trunking
Default routes
IP unicast and multicast forwarding
Simple IP access control lists (ACLs) (both Layer 2 and Layer 3 forwarding path)
Extended IP ACLs in software (control-plane only)
IP and IP multicast routing and switching between Ethernet ports
Reverse Path Forwarding (RPF) multicast (not RPF unicast)
Load balancing among equal cost paths based on source and destination IP addresses
Up to 18,000 IP routes
Up to 20,000 IP host entries
Up to 40 IP multicast groups
IRB routing mode support
Virtual Private Network (VPN) Routing and Forwarding Lite (VRF Lite)
Chapter 1 ML-Series Card Overview