Configuring Rpr-Ieee End-To-End - Cisco ONS 15454 SDH Configuration Manual

Configuring RPR-IEEE End-to-End

Advertised Protection requests:
Active Edges:
Preferred protection mode: STEERING
Jumbo preference: NOT SET (ring doesn't supports JUMBOS)
Measured LRTT: 0
Sequence Number: 3
ATD INFO:
Station Name: ML100T-481
A0 reserved Bandwidth:
SAS enabled: YES
Weight:
Secondary Mac Addresses:
Configuring RPR-IEEE End-to-End
You need to use both CTC and Cisco IOS to configure RPR-IEEE for the ML-Series card. CTC is the
graphical user interface (GUI) that serves as the enhanced craft tool for specific ONS node operations,
including the provisioning of the point-to-point SONET/SDH circuits required for RPR-IEEE. Cisco
IOS is used to configure RPR-IEEE on the ML-Series card and its interfaces.
Successfully creating an RPR-IEEE requires these procedures:
•
•
•
•
High-level data link control (HDLC) framing is not supported.
Caution
You can use TL-1 to provision the required SONET/SDH point-to-point circuits instead of CTC.
Note
Provisioning Card Mode
The first task in creating an end-to-end RPR-IEEE is to set the CTC card mode to 802.17. For more
information on this task, see the
Connecting the ML-Series Cards with Point-to-Point STS/STM Circuits
You connect the ML-Series cards in an RPR-IEEE through point-to-point STS/STM circuits. These
circuits use the ONS 15454 SONET/SDH network and are provisioned using CTC in the same general
manner as provisioning ONS 15454 SONET/SDH optical circuits. After putting the ML-Series card in
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
26-30
ringlet0: IDLEringlet1: IDLE
ringlet0: NO ringlet1: NO
ringlet0: 0 mbpsringlet1: 0 mbps
ringlet0: 1ringlet1: 1
MAC 1: 0000.0000.0000 (UNUSED)
MAC 2: 0000.0000.0000 (UNUSED)
Provisioning Card Mode, page 2-4
Connecting the ML-Series Cards with Point-to-Point STS/STM Circuits, page 26-30
Creating the RPR-IEEE Interface and Bridge Group, page 26-32
Verifying RPR-IEEE End-to-End Ethernet Connectivity, page 26-37
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
(CTC)
"Provisioning Card Mode" section on page
(CTC or TL1)
(Cisco IOS)
(Cisco IOS)
2-4.