Monitoring And Verifying Vlan Operation - Cisco ONS 15454 SDH Configuration Manual

Chapter 8 Configuring VLANs
pos flag c2 1
!
interface POS0.1
encapsulation dot1Q 1 native
bridge-group 1
!
interface POS0.2
encapsulation dot1Q 2
bridge-group 2
!
interface POS0.3
encapsulation dot1Q 3
bridge-group 3
!
interface POS0.4
encapsulation dot1Q 4
bridge-group 4

Monitoring and Verifying VLAN Operation

After the VLANs are configured on the ML-Series card, you can monitor their operation by entering the
privileged EXEC command show vlans vlan-id. This command displays information on all configured
VLANs or on a specific VLAN (by VLAN ID number).
An example of the show vlans privileged EXEC command commands are shown here:
Example 8-2
ML1000-121#show vlans
Virtual LAN ID:
GigabitEthernet0
POS1
GigabitEthernet0
Virtual LAN ID:
GigabitEthernet0.1
show vlans Commands
1 (IEEE 802.1Q Encapsulation)
vLAN Trunk Interfaces:
This is configured as native Vlan for the following interface(s) :
Protocols Configured:
5 (IEEE 802.1Q Encapsulation)
vLAN Trunk Interfaces:
Protocols Configured:
Bridging Bridge Group 2
Bridging Bridge Group 2
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
POS1
Address: Received:
POS1.1
Address: Received:
157
157
Monitoring and Verifying VLAN Operation
Transmitted:
Transmitted:
0
0
8-5