Cisco ONS 15454 SDH Configuration Manual page 92

Monitoring and Verifying POS
Concatenation: CCAT
Alarms reportable to CLI: PAIS PLOP PUNEQ PTIM PPLM ENCAP PRDI PPDI BER_SF_B3 BER_SD_B3
VCAT_OOU_TPT LOM SQM
Link state change defects: PAIS PLOP PUNEQ PTIM PPLM ENCAP PRDI PPDI BER_SF_B3
Link state change time
***************
Circuit state: IS
PAIS
PPLM
BER_SF_B3 = 0
NEWPTR
Active Alarms : PAIS
Demoted Alarms: None
Active Defects: PAIS
DOS FPGA channel number
Starting STS (0 based)
VT ID (if any) (0 based) : 255
Circuit size
RDI Mode
C2 (tx / rx)
Framing
Path Trace
Mode
Transmit String :
Expected String :
Received String :
Buffer
Remote hostname :
Remote interface:
Remote IP addr
B3 BER thresholds:
SFBER = 1e-4,
0 total input packets,
0 input short packets,
0 input long packets , 0
0 input CRCerror packets , 0
0 input abort packets
0 input packets dropped by ucode
0 total output packets, 0
0 output post-HDLC bytes
Carrier delay is 200 msec
The show interface pos {0 | 1} command
Example 5-2
ML_Series# show interface pos 0
POS0 is administratively down, line protocol is down
Hardware is Packet/Ethernet over Sonet, address is 0011.2130.b340 (bia 0011.2130.b340)
MTU 1500 bytes, BW 145152 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation: Cisco-EoS-LEX, crc 32, loopback not set
Keepalive set (10 sec)
Scramble enabled
ARP type: ARPA, ARP Timeout 04:00:00
Last input 01:21:02, output never, output hang never
Last clearing of "show interface" counters 00:12:01
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
5-10
: 200 (msec)
Path ***************
= 0 PLOP = 0
= 0 PUNEQ = 0
BER_SD_B3 = 0
= 0 PSE = 0
: 0
: 0
: STS-3c
: 1 bit
: 0x01 / 0x01
: SONET
: off
: Stable
:
SDBER = 1e-7
0 post-HDLC bytes
0 pre-HDLC bytes
input runt packets
input drop packets
output pre-HDLC bytes
show interface pos [0 | 1] Command
PRDI = 0
PPDI = 0
BIP(B3) = 0
NSE = 0
(Example 5-2) shows scrambling.
Chapter 5 Configuring POS
PTIM = 0
PTIU = 0
REI = 0
ENCAP = 0