Chapter 18 Configuring Ethernet over MPLS
Table 18-3
Command
show mpls traffic-eng link-management
igp-neighbors
show mpls traffic-eng link-management
interfaces
show mpls traffic-eng link-management summary
show mpls traffic-eng topology
show mpls traffic-eng tunnel
show mpls traffic-eng tunnel summary
Table 18-2
on the ML-Series cards.
Table 18-4
Command
show ip rsvp interface
[ interface-type interface-number ]
show ip rsvp installed
[ interface-type interface-number ]
show ip rsvp neighbor
[ interface-type interface-number ]
show ip rsvp sender [ interface-type
interface-number ]
show ip rsvp request
[ interface-type interface-number ]
show ip rsvp reservation
[ interface-type interface-number ]
RPRW Alarm
For information on the ONS 15454 RPRW alarm, refer to the Cisco ONS 15454 Troubleshooting Guide,
Release 5.0.
Commands for Monitoring and Verifying MPLS-TE (continued)
shows the privileged EXEC commands supported to monitor and verify the state of IP RSVP
Commands for Monitoring and Verifying IP RSVP
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Purpose
Displays IGP neighbors.
Displays interface resource and
configuration information.
Displays a summary of link
management information including
link counts.
Displays the MPLS-TE global
topology as currently known at this
node.
Displays information about
MPLS-TE tunnels, including LSP
Tunnels Process and RSVP process.
Displays condensed information
about MPLS-TE tunnels.
Purpose
Displays Resource Reservation Protocol (RSVP)-related
information.
Displays RSVP-related installed filters and corresponding
bandwidth information.
Displays current RSVP neighbors.
Displays RSVP path-related sender information currently
in the database.
Displays RSVP-related request information being
requested upstream
Displays RSVP-related receiver information currently in
the database
RPRW Alarm
18-19