Configuring Mpls-Te; Configuring An Ml-Series Card For Tunnels Support; Configuring An Interface To Support Rsvp-Based Tunnel Signalling And Igp Flooding - Cisco ONS 15454 SDH Configuration Manual

Configuring MPLS-TE

Ethernet FCS preservation is off by default on the ML-Series card. Configure Ethernet FCS preservation
at the interface or sub-interface configuration level with the [no] fcs-preservation-on command. To
operate correctly, both ends of the EoMPLS tunnel need to be configured for FCS preservation.
Configuring MPLS-TE
Perform the following tasks on the MPLS network before you enable MPLS-TE on the ML-Series card:
•
•
To configure MPLS-TE on the ML-Series card, perform the tasks described in the following sections:
•
•
•
•
Note The ML-Series card does not support MPLS-TE with IS-IS.
Cisco Express Forwarding (CEF) is on by default on the ML-Series card.
Note

Configuring an ML-Series Card for Tunnels Support

To configure an ML-Series card to support tunnels, use the following commands in global configuration
mode:
Command
Step 1
Router(config)# mpls traffic-eng tunnels
Configuring an Interface to Support RSVP-Based Tunnel Signalling and IGP
Flooding
To configure an interface to support RSVP-based tunnel signalling and IGP flooding, use the following
commands in interface configuration mode:
You must enable the tunnel feature on interfaces or sub-interfaces that you want to support
Note
MPLS-TE.
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
18-14
Turn on MPLS tunnels
Turn on OSPF
Configuring an ML-Series Card for Tunnels Support

Configuring an Interface to Support RSVP-Based Tunnel Signalling and IGP Flooding

Configuring OSPF and Refresh Reduction for MPLS-TE
Configuring an MPLS-TE Tunnel
Chapter 18 Configuring Ethernet over MPLS
Purpose
Enables the MPLS-TE tunnel feature on a device.