Cisco ONS 15454 SDH Configuration Manual page 188

Configuring EIGRP
Command
Step 1
Router# configure terminal
Step 2
Router(config)# interface interface-id
Step 3
Router(config)# ip bandwidth-percent
eigrp autonomous-system-number percent
Step 4
Router(config)# ip summary-address
eigrp autonomous-system-number address
mask
Step 5
Router(config)# ip hello-interval eigrp
autonomous-system-number seconds
Step 6
Router(config)# ip hold-time eigrp
autonomous-system-number seconds
Step 7
Router(config)# no ip split-horizon
eigrp autonomous-system-number
Step 8
Router# end
Step 9
Router# show ip eigrp interface
Step 10
Router# copy running-config
startup-config
Use the no forms of these commands to disable the feature or return the setting to the default value.
Example 11-9
Example 11-9 show ip eigrp interface Privileged EXEC Command Output
Router# show ip eigrp interface
IP-EIGRP interfaces for process 1
Interface
PO0
Fa0
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
11-24
shows the output of the show ip eigrp interface privileged EXEC command.
Xmit Queue Mean
Peers Un/Reliable SRTT
1 0/0 20
0 0/0
Chapter 11 Configuring Networking Protocols
Purpose
Enters global configuration mode.
Enters interface configuration mode, and specifies the
Layer 3 interface to configure.
(Optional) Configures the maximum percentage of
bandwidth that can be used by EIGRP on an interface.
The default is 50 percent.
(Optional) Configures a summary aggregate address
for a specified interface (not usually necessary if
autosummary is enabled).
(Optional) Changes the hello time interval for an
EIGRP routing process. The range is 1 to 65535
seconds. The default is 60 seconds for low-speed
NBMA networks and 5 seconds for all other networks.
(Optional) Changes the hold time interval for an
EIGRP routing process. The range is 1 to 65535
seconds. The default is 180 seconds for low-speed
NBMA networks and 15 seconds for all other
networks.
Do not adjust the hold time without
Caution
consulting Cisco technical support.
(Optional) Disables split horizon to allow route
information to be advertised by a router out any
interface from which that information originated.
Returns to privileged EXEC mode.
Displays the interfaces that EIGRP is active on and
information about EIGRP relating to those interfaces.
(Optional) Saves your entries in the configuration file.
Pacing Time Multicast
Un/Reliable Flow Timer
0/10 50
0 0/10
Pending
Routes
0
0 0