Cisco ONS 15454 SDH Configuration Manual page 174

Configuring OSPF
Table 11-2
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
Router ID
Summary address
Timers LSA group pacing
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
11-10
Default OSPF Configuration
Default Setting
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mbps.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110
dist2 (all routes from one area to another): 110
dist3 (routes from other routing domains): 110
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
No OSPF routing process defined.
Disabled.
240 seconds.
Chapter 11 Configuring Networking Protocols