Bgp; Enabling Ip Routing - Cisco ONS 15454 SDH Configuration Manual

Chapter 11 Configuring Networking Protocols
Command
Step 1
Router(config)# router ospf process-ID
Step 2
Router(config-router)# network
net-address wildcard-mask area area-ID
Step 3
Router(config-router)# end

BGP

To configure the Border Gateway Protocol (BGP), perform the following procedure, beginning in global
configuration mode:
Command
Step 1
Router(config)# router bgp
autonomous-system-number
Step 2
Router(config-router) # network
net-number
Step 3
Router(config-router)# exit

Enabling IP Routing

Beginning in privileged EXEC mode, follow this procedure to enable IP routing:
By default, IP routing is already enabled.
Note
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Purpose
Defines OSPF as the IP routing protocol.
The process ID identifies a unique OSPF router
process. This number is internal to the ML-Series
card only; the process ID here does not have to
match the process IDs on other routers.
Assigns an interface to a specific area.
The net-address is the address of directly
•
connected networks or subnets.
The wildcard-mask is an inverse mask that
•
compares a given address with interface
addressing to determine whether OSPF uses this
interface.
The area parameter identifies the interface as
•
belonging to an area.
• The area-ID specifies the area associated with
the network address.
Returns to privileged EXEC mode.
Purpose
Defines BGP as the IP routing protocol.
The autonomous system number is the autonomous
system to which this ML-Series card belongs.
Defines the directly connected networks that run
BGP.
The network number is the number of the network
that is advertised by this ML-Series card.
Returns to global configuration mode.
BGP
11-3