Configuring Access Control List Size In Tcam; Monitoring And Verifying Sdm; Table 15-2 Partitioning The Tcam Size For Acls - Cisco ONS 15454 SDH Configuration Manual

Chapter 15 Configuring the Switching Database Manager

Configuring Access Control List Size in TCAM

The default maximum size of the ACL is 300 64-bit entries. You can enter the sdm access-list command
to change the maximum ACL database size, as shown in
Table 15-2
Task
sdm access-list number-entries
An example of this is shown in
Example 15-2 Configuring Entries for the ACL Region in TCAM
ML_Series# configure terminal
ML_Series(config)# sdm access-list 100
ML_Series(config)# end

Monitoring and Verifying SDM

To display the number of available TCAM entries, enter the show sdm size command from global
configuration mode:
ML_Series # show sdm size
Active Switching Database Region Maximum Sizes :
Partitioning the TCAM Size for ACLs
IP Adjacency : 300
IP Prefix : 300
QoS Classifiers : 300
IP VRF Prefix : 300
IP Multicast : 300
MAC Addr : 8192
Access List : 300
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Table
Command
Sets the name of the application region for which you want to
configure the size. You can enter the size as an absolute number
of entries.
Example 15-2.
64-bit entries
64-bit entries
64-bit entries
64-bit entries
64-bit entries
64-bit entries
64-bit entries
Configuring Access Control List Size in TCAM
15-2.
15-3