Monitoring Operations On The Fast Ethernet And Gigabit Ethernet Interfaces - Cisco ONS 15454 SDH Configuration Manual

Monitoring Operations on the Fast Ethernet and Gigabit Ethernet Interfaces

Command
Step 3
Router(config)#int pos0
Router(config-if)#trigger crc-error delay
<soak_time_in_minutes>
Step 4
Router(config-if)#no trigger crc-error
delay <soak_time_in_minutes>
Step 5
Router(config)#int pos0
Router(config-if)#trigger crc-error action
Step 6
Router(config-if)#no trigger crc-error
action
Monitoring Operations on the Fast Ethernet and Gigabit Ethernet
Interfaces
To verify the settings after you have configured the interfaces, enter the show interface command. For
additional information about monitoring the operations on POS interfaces, see the
chapter.
Example 4-8
interface including port speed and duplex operation.
Example 4-8
Router# show interface fastEthernet 0
FastEthernet1 is administratively down, line protocol is down
Hardware is epif_port, address is 000d.bd5c.4c85 (bia 000d.bd5c.4c85)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto Speed, 100BaseTX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
4-12
shows the output from the show interface command, which displays the status of the
show interface Command Output
Chapter 4 Configuring Interfaces
Purpose
Sets the number of consecutive minutes for which
excessive CRC errors should be seen to raise an
excessive CRC indication. The valid values are
from 3 minutes to 10 minutes. Default is
10minutes.
Sets the soak value back to the default of 10
minutes.
Enable trigger action. This configuration will
bring the interface down on seeing CRC errors
greater than configured <threshold value> for soak
time period.
Disables trigger action.
"Configuring POS"