Cisco ONS 15454 SDH Configuration Manual page 556

spr-intf-id shared-packet-ring-number
spr-intf-id shared-packet-ring-number
Use this command to assign the POS interface to the SPR interface.
Syntax Description Parameter
shared-packet-ring-number
Defaults
N/A
Command Modes POS interface configuration
Usage Guidelines
•
•
•
Note
Examples In this example, interface is shortened to int. An ML-Series card POS interface is being assigned to an
SPR interface with a shared-packet-ring-number of 1:
Router(config)# interface pos 0
Router(config-if)# spr-intf-id 1
Related Commands interface spr 1
spr station-id
spr wrap
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-80
The SPR number must be 1, which is the same SPR number assigned to the SPR interface.
The members of the SPR interface must be POS interfaces.
An SPR interface is configured similarly to a EtherChannel (port-channel) interface. Instead of
using the channel-group command to define the members, you use the spr-intf-ID command. Like
port-channel, you then configure the SPR interfaces instead of the POS interface.
A similar command, the spr drpri-id [0 | 1] command, is not supported in R7.2.
Description
The only valid shared-packet-ring-number (SPR number) is 1.
Appendix A Command Reference