Configuring Snmp; Default Snmp Configuration; Snmp Configuration Guidelines - Cisco ONS 15454 SDH Configuration Manual

Configuring SNMP

Configuring SNMP
This section describes how to configure SNMP on your ML-Series card. It contains this configuration
information:
•
•
•
•
•
•
•
•
•

Default SNMP Configuration

Table 22-2
Table 22-2
Feature
SNMP agent
SNMP community strings
SNMP trap receiver
SNMP traps
SNMP version
SNMP notification type

SNMP Configuration Guidelines

When configuring SNMP, follow these guidelines:
•
•
•
•
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
22-6
Default SNMP Configuration, page 22-6
SNMP Configuration Guidelines, page 22-6
Disabling the SNMP Agent, page 22-7
Configuring Community Strings, page 22-7
Configuring SNMP Groups and Users, page 22-9
Configuring SNMP Notifications, page 22-10
Setting the Agent Contact and Location Information, page 22-12
Limiting TFTP Servers Used Through SNMP, page 22-13
SNMP Examples, page 22-13
shows the default SNMP configuration.
Default SNMP Configuration
When configuring an SNMP group, do not specify a notify view. The snmp-server host global
configuration command autogenerates a notify view for the user and then adds it to the group
associated with that user. Modifying the group's notify view affects all users associated with that
group. For information about when you should configure notify views, see the Cisco IOS
Configuration Fundamentals Command Reference, Release 12.2.
An SNMP group is a table that maps SNMP users to SNMP views.
An SNMP user is a member of an SNMP group.
An SNMP host is the recipient of an SNMP trap operation.
Default Setting
Enabled
Read-Only: Public
Read-Write: Private
Read-Write-all: Secret
None configured
None enabled except the trap for TCP connections (tty)
If no version keyword is present, the default is Version 1.
If no type is specified, all notifications are sent.
Chapter 22 Configuring SNMP