Cisco ONS 15454 SDH Configuration Manual page 305

Chapter 18 Configuring Ethernet over MPLS
Command
Step 1
Router(config)# mpls label protocol ldp
Step 2
Router(config)# interface loopback0
Step 3
Router(config-if)# ip address ip-address
255.255.255.255
Step 4
Router(config)# interface {GigabitEthernet |
FastEthernet} interface-number
Step 5
Router(config-if)# no ip address
Step 6
Router(config-subif)# mpls l2transport route
destination vc-id
or
xconnect destination vc-id encapsulation mpls
Step 7
Router(config-subif)# end
Step 8
Router# show mpls l2transport vc
Step 9
Router# copy running-config startup-config
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
VC Type 5 Configuration on PE-CLE Port
Purpose
Specifies LDP as the label distribution protocol.
LDP must be specified. The ML-Series card does not
operate EoMPLS with the default TDP as the label
distribution protocol.
Enters loopback interface configuration mode.
Assigns an IP address to the loopback interface. This
loopback IP addresses is used to identify the peer in the
EoMPLS point-to-point session.
No subnet mask is needed.
Specifies the Ethernet interface for the imposition
interface.
Disables the IP address if an IP address is assigned.
By entering the mpls l2transport route or the xconnect
interface configuration command on a VLAN for
VLAN-based EoMPLS, you can configure an EoMPLS
tunnel to forward traffic based on the customer VLAN.
mpls l2transport route specifies the VC to use to
transport the VLAN packets. Initiates a remote LDP
session with the peer point-to-point endpoint interface.
destination specifies the loopback IP address for the
•
remote ML-Series at the other end of the VC
(PE-CLE).
• vc-id is a value you supply. It must be unique for
each VC. The VC ID is used to connect the
endpoints of the VC. Specify the same VC ID on
both ends of the VC.
xconnect binds the 802.1q VLAN circuit to a pseudo
wire for xconnect service. The encapsulation mpls
pseudo wire class parameter specifies MPLS for the
tunneling method.
The xconnect command is a newer version of the
Note
mpls l2transport route interface configuration
command.
Use the no mpls l2transport route destination
Note
vc-id or no xconnect destination vc-id
encapsulation mpls interface command to
delete the EoMPLS tunnel.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file
18-7